Build Guide

Things to note: No glue is required. However, it is recommended to print on paper with at least 120 GSM. 160 GSM would be the optimum choice.

1. Start of by cutting out the template

2. Cut the red slots, S1 to S17, as indicated below.

3. Fold along all the lines.

4. Referring to below, Insert F1 all the way into S11 and pull it out from S12. Insert F2 into S15. Do the same for the other side.

5. Insert F3 into S1 and F4 into S4 as indicated below.

6. Referring to above, fold F5 and F6 along the line between them, making sure the back of F5 and F6 are touching each other. Insert F5/6 all the way into S2 and  pull it out from S3. Do the same for the other side

7. Insert F5 into S7 and F6 into S9 as indicated below.

8. Finish by inserting F7 into S8 and F8 into S9 as indicated above

9. Enjoy your new PixelBlox